Boat-Building and Boating. Daniel Carter Beard
Читать онлайн книгу.
lake; and ever afterward when we wanted a boat we knew a simple and inexpensive way to make one—and a safe one, too.
The Crusoe Raft
is another rustic craft, but it is of more ambitious dimensions than the "Man-Friday." Instead of being able to float only one or two passengers, the "Crusoe," if properly built, ought to accommodate a considerable party of raftsmen. Of course the purpose for which the raft is to be used, and the number of the crew that is expected to man it, must be taken into consideration when deciding upon the dimensions of the proposed craft.
All the tools that are necessary for the construction of a good stout raft are an axe, an auger, and a hatchet, with some strong arms to wield them.
The building material can be gathered from any driftwood heap on lake or stream.
For a moderate-sized raft collect six or seven logs, the longest not being over sixteen feet in length nor more than a foot in diameter; the logs must be tolerably straight. Pick out the longest and biggest for the centre, sharpen one end, roll the log into the water, and there secure it.
Select two logs as nearly alike as possible, to lie one at each side of the centre log. Measure the centre log, and make the point of each side log, not at its own centre, but at that side of it which will lie against the middle log, so that this side point shall terminate where the pointing of the middle log begins (see Fig. 9).
Fig. 9.—Plan of Crusoe raft.
After all the logs needed have been trimmed and sharpened in the manner just described, roll them into the water and arrange them in order (Fig. 9). Fasten them together with "cross-strips," boring holes through the strips to correspond with holes bored into the logs lying beneath, and through these holes drive wooden pegs. The pegs should be a trifle larger than the holes; the water will cause the pegs to swell, and they will hold much more firmly than iron nails.
Fig. 10.—Skeleton of Crusoe raft.
Fig. 11.—Crusoe with cabin covered.
The skeleton of the cabin can be made of saplings; such as are used for hoop-poles are the best.
These are each bent into an arch, and the ends are thrust into holes bored for that purpose. Over this hooping a piece of canvas is stretched, after the manner of old-fashioned country wagons (Figs. 10 and 11).
Erect a "jack-staff," to be used as a flag-pole or a mast to rig a square sail on.
A stout stick should be erected at the stern, and a similar one upon each side of the raft near the bow; these sticks, when their ends are made smaller, as shown in the illustration (Fig. 10), serve as rowlocks.
Fig. 12.—Sweeps.
For oars use "sweeps"—long poles, each with a piece of board for a blade fastened at one end (Fig. 12).
Holes must be bored through the poles of the sweeps about three feet from the handle, to slip over the pegs used as rowlocks, as described above. These pegs should be high enough to allow the oarsman to stand while using the sweeps.
A flat stone or earth box placed at the bow will serve as a fireplace.
If the cracks between the logs under the cabin are filled up to prevent the water splashing through, and the cabin is floored with cross-sticks, a most comfortable bed at night can be made of hay, by heaping it under the canvas cover in sufficient quantities.
The Crusoe raft has this great advantage over all boats: you may take a long trip down the river, allowing the current to bear you along, using the sweeps only to assist the man at the helm (rear sweep); then, after your excursion is finished you may abandon your raft and return by steam-boat or train. A very useful thing to the swimmers, when they are skylarking in the water, is
The Chump's Raft
Its construction is simple. Four boards, each about six feet long, are nailed together in the form of a square, with the ends of the boards protruding, like the figure drawn upon a school-boy's slate for the game of "Tit, tat, toe" (Fig. 13).
Fig. 13.—The chump's raft.
All nail-points must be knocked off and the heads hammered home, to prevent serious scratches and wounds on the bather's body when he clambers over the raft or slips off in an attempt to do so (Fig. 14).
Beginners get in the middle hole, and there, with a support within reach all around them, they can venture with comparative safety in deep water.
Fig. 14.—A beginner in a chump's raft.
The raft, which I built as a model fifteen years ago, is still in use at my summer camp, where scores of young people have used it with a success proved by their present skill as swimmers. But many camps are located in a section of the country where boards are as scarce as boarding-houses, but where timber, in its rough state, exists in abundance. The campers in such locations can make
A Chump's Raft of Logs
Fig. 15.—Looking down on a chump's raft in motion.
Fig. 16.—Side view of chump's log raft.
Such a float consists of two dried logs fastened together at each end by cross-slabs, so as to form a rude catamaran. These rafts can be towed through deep water by a canoe or row-boat, with the tenderfoot securely swung in a sling between the logs, where he may practice the hand-and-foot movement with a sense of security which only the certainty that he is surrounded by a wooden life-preserver will give him. Fig. 15 shows a top view of the new chump's raft. In Fig. 16 the two logs are connected fore and aft by cross-slabs; two more upright slabs are nailed securely to the side of the logs; notches having been